KL2.5LM(T) Intrinsically Safe Explosion-proof Light is the latest development of Wenzhou Dr. Electric Technology Co., Ltd., used for mobile lighting for Ex ia I Ma including explosive gas mines, natural gas development platforms and other industries.

This product implements the following standards:

Explosive atmospheres - Part 1: General requirements for equipment GB 3836.1-2010.

Explosive atmospheres - Part 4: Equipment protected by intrinsically safe "i" GB 3836.4-2010.

Product Features

  • 1. This product is an intrinsically safe explosion-proof lamp, which works safely in the inflammable and explosive places in Zone 0, Zone I and Zone II.
  • 2. Solid-state maintenance-free LED light source with high luminous efficiency, long life and an average life of up to 100,000 hours.
  • 3. With main light source and auxiliary light source, it can be freely converted through the switch, and will automatically convert to secondary light source when the power is low.
  • 4. Made of reinforced nylon, it has good impact resistance, waterproof, dustproof, insulation and corrosion resistance, and can be used in various harsh environments.
  • 5. It adopts high-energy polymer lithium-ion battery, which has good charge and discharge performance and triple protection function, which makes the battery meet the requirements of intrinsic safety, safety and environmental protection.
  • 6. Long lighting time, more than 11 hours.

Precautions when using

  • 1.KL2.5LM(T) Intrinsically safe miner's lamp has been charged about 50% at the factory, and will be filled with charger before use.
  • 2. Please use the charger or charging stand of this miner's lamp to charge. If you use other types of chargers, it will damage the lamp.
  • 3. If it is not used for a long time, please follow the steps below for maintenance, complete charging → full discharge → 2 hours charging maintenance operation.

Simple troubleshooting method

Unable to turn on the light after pressing the button may be the cause of the battery running out. The miner's lamp will turn on the automatic protection and need to be charged in time.

The miner's lamp discharge time is less than 11 hours or is not fully charged, make sure the battery is lit and the green light is on.

If the brightness of the miner's lamp is reduced, it is likely that the lamp cover is dirty and should be cleaned with water in time.